FRP Cooling towers are of vertical induced draft counter flow design with uniform water distribution and optimal heat transfer. Towers can be installed independent of wind direction. The tower casing is made from tough fiberglass and has sufficient strength to withstand high velocities and vibrations. The water collection sump is leak proof and avoids water spillage.
The performance of cooling tower greatly depends upon the water distribution over the fills. ABC nozzles distribute water evenly through a wide spray angle without any dry pockets. The fill is of rigid Poly Vinyl Chloride (PVC) and is of honeycomb design with very large contact surface area.
Cooling Tower Casing is made of selected grade materials of tough fiber glass reinforced polyester & resins, etc. Additional embossing is done for extra strength in case of big cooling towers.
Honeycomb/Film Fills ring type, PVC/PP fills are used for extended contact area having a high heat transfer efficiency. The crossing of air & water streams near which creates a diffused turbulence conducive to evaporation & efficient heat transfer.
is completely leak proof which avoids spillage & seepage of water. It is of deep sump design to ensure maximum water level at all times & made up of FRP with additional stiffening to take care of extra water weight. However, RCC basin is recommended for capacities 300TR and above.
Automatic rotary sprinkler system made of Nylon 66 material, with rotary head and sprinkler pipe distributes the hot water over the entire space of the filler. Sprinkler pipes are non-clogging, require low pressure to operate and assures uniform water flow.with minimum operating pumphead.
Superflow cast Aluminium alloy FRP fan is of aero dynamic designed axial flow type to achieve high efficiency.
To reduce carry out losses through entrainment of moisture drops in the stream by specially designed multi blade rotary drift eliminator made of FRP sheets/Aluminum. Additional PVC eliminator is provided in large capacity cooling towers.
Special low RPM totally enclosed motors of Vertical, Flange type with enlarged & threaded shaft and sealed top is supplied with the cooling tower. The motor is also weather proof and in IP-55 construction.
All components like tower supports, motor supports, leg supports, etc. are either hot dip galvanized or epoxy coated. Hardware is Galvanized Steel. Stainless Steel or Phosphor Bronze hardware can be supplied on request at extra cost.
3TR to 700TR in single cell
